Recirculating - GE CVM521P2MS1 Instrucciones De Instalación

C

RECIRCULATING

INSTALLATION OVERVIEW
C1.
C2.
C3. Check Blower Motor Orientation
C4. Adapt Blower for Recirculation
C5. Mount the Microwave Oven
C6. Install Charcoal Filter
ATTACH THE MOUNTING
C1
PLATE TO THE WALL
A
C
Attach the plate to the wall using toggle bolts. At least
one wood screw must be used to attach the plate to
a wall stud. Recommended locations on the mounting
1
Remove the toggle wings from the bolts.
2 Insert the bolts into the mounting plate through
reattach the toggle wings to
To use toggle bolts:
Spacing for
Mounting
Bolt
Wall
20
Installation Instructions
(Non-Vented Ductless)
B
D
onto each bolt.
3 4
Bolt End
3
insert the toggle wings into the holes in the wall
to mount the plate.
screw, make sure the tabs on the mounting plate
touch the bottom of the cabinet when pushed
centered under the cabinet.
CAUTION
Be careful to avoid pinching
fingers between the back of
the mounting plate and the wall.
4
to help tighten the bolts.
C2.
USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
You need to drill holes for the top support screws and
a hole large enough for the power cord to fit through.
• Drill the holes, following the instructions on the
CAUTION
Wear safety goggles when
drilling holes in the cabinet bottom.