GE CVM521P2MS1 Instrucciones De Instalación página 18

ADAPTING MICROWAVE
B4.
BLOWER FOR OUTSIDE
BACK EXHAUST (cont.)
5
Reroute the wires through grooves on other side
of the blower unit.
Before Rerouting
Right Side
Roll the blower unit 90° so that fan blade
6
openings are facing out the back of the
microwave.
Before Rolling
Back of
Microwave
Oven
7
knockouts; this will allow the ventilation fan
airflow to exhaust out the rear of the oven.
CAUTION
after removing the knockout plates.
18
Installation Instructions
After Rerouting
Side
After Rolling
Back of
Microwave
Oven
Be sure to trim the sharp
edges from the openings
8
match exhaust openings on rear of microwave.
CAUTION
the blower unit wiring.
Make sure the wires are not pinched.
AFTER: Fan Blade
Openings Facing Back
End B
9
Close the blower door. Slide blower shield onto
the top of the blower door opening. Secure the
blower to the microwave oven using the blower
retaining screws from Step 1 except the upper
blower motor retaining screw
Back of
Microwave
Oven
Slide the exhaust adaptor onto the back
10
of the microwave oven, securing it into the
the damper hinge is installed so that it is at
Reinstall the upper blower motor screw
through the adaptor and the blower door and
into the back of the microwave oven.
Guide
Adaptor
Do not pull or stretch
End A
Blower Retaining
Screw
Blower Shield
Blower
Retaining
Screw
Back of
Microwave Oven
Guide
Blower Motor
Door Retaining
Screw