Warranty And Service Information; Warranty Conditions - Parkside PDSS 400 A1 Instrucciones De Funcionamiento

Faults
Impact driver not
working.
Not properly
tightening
screw.
Not loosening
screw.
z Warranty and service
information
Warranty from Creative Marketing &
Consulting GmbH
Dear Customer, The warranty for this device
is 3 years from the date of purchase. In the
event of product defects, you have legal
rights against the retailer of this product.
Your statutory rights are not affected in any
way by our warranty conditions, which are
described below.
Troubleshooting / Warranty and service information
Possible causes
Trigger not pulled.
3
No compressed air
supply.
Leak in compressed air
system.
Compressor defective.
Defect inside the air tool.
Air pressure too low.
Torque is too low.
Rusted screw.
Action
Pull trigger .
3
If applicable, drain condensation from tube
(water bag).
Straighten kinks in the hose.
Connect compressed
Remedy leak.
Verify the compressor is supplying com-
pressed air. If necessary, have compressor
repaired by a qualified professional.
Have air tool repaired by a qualified
professional.
Increase air pressure.
ATTENTION! Never exceed the maximum
approved operating pressure of the air tool!
Turn the switch control
setting.
Apply rust remover to screw.
z Warranty conditions
The warranty period begins on the date of
purchase. Please retain the original sales
receipt. This document is required as your
proof of purchase. Should this product show
any defect in materials or manufacture within
3 years from the date of purchase, we will
repair or replace it – at our discretion – free
of charge. To claim against this warranty,
you must present the defective device and
your purchase receipt within the 3-year pe-
riod, and include a brief written description
of the nature of the defect and the date it
occurred. If the defect is covered by our war-
ranty, we will repair and return your product
air.
2
to a higher
1
GB/MT 61