General Descriptions - Cebora 452 Manual De Instrucciones

REMOTE CONTROL PANEL INSTRUCTION MANUAL

1 GENERAL DESCRIPTIONS

All maintenance jobs must be performed by profes-
sional personnel according to the IEC 26-29 (IEC
60974-4) standard.
When performing maintenance inside the device, make
sure switch s in "O" position and that the power supply
cable is disconnected from the mains.
Periodically, also clean the inside of the appliance and
remove any metal dust using compressed air.
WHAT TO DO AFTER A REPAIR.
After a repair, be careful to arrange the wiring to ensu-
re secure insulation between the primary side and the
secondary side of the machine. Avoid the wires coming
into contact with moving parts or parts that heat up du-
ring operation. Refi t all the cable ties as they were on the
original device so as to avoid any contact between the
6
primary and secondary side in case of accidental wire
breakage or disconnection.
Also, fi t the screws back on with the notched washers as
on the original machine.
The article Art.452 through the connection Art.2065 is
connected to the connector CN3 located on the rear pa-
nel of the power source Art.372-80 or Art.374-80.
To enable this control panel to operate, the front panel of
the power source must be removed by unscrewing the 4
screws, see fi gure below.
An electronic board is fi xed to the back of this panel.
On this boad there is a small blue switch that has the 2
selectors positioned on ON, these must be brought on 1
and 2 position (see fi g. below)