Ordering Replacement Parts - EINHELL FSM 920 NIRO Manual De Instrucciones

Anleitung FSM 920 NIRO 30.06.2004
GB
7.2. Adjusting the upper wheel guard
(Fig. 3)
Insert the adjusting bracket (23) in the splitter
holder (11) from above through the table top an
lock with the Allen screw.
Position the wheel guard around 5 mm above the
tile you want to cut. Lock the wheel guard in
place with the screw marked in the drawing.
Caution! The machine has a cutting wheel with
an all-round cutting edge.
8. Operation
8.1 Plain cuts (Fig. 1/4)
Set the cutting width the parallel stop (2) and
lock with the thumb screws. The width of the
piece you want to use can be read off the
centimetre scales.
Figure 4 shows the correct position of your
hands when making plain cuts. Be sure to adapt
the feed speed to the cutting capacity of the
wheel. This will ensure that no material is
catapulted off the tile, resulting in accidents or
injuries.
Important! Always check the level of water.
8.2 45° mitre cuts (jolly) (Fig. 5)
Position the table as shown in the drawing and
lock in place with the handles. Position the
cutting guide around 2 mm from the diamond
cutting wheel and secure with the thumb screws.
Place the tile, glazed side down, on the work top
and make sure that the diamond wheel does not
touch the glaze. If necessary, correct the position
of the cutting guide.
Figure 5 shows the correct position of your
hands when making 45° mitre cuts. Use your
right hand to keep the tile in contact with the
diamond wheel and your left hand to feed the
tile. Be sure to adapt the feed speed to the
cutting capacity of the wheel. This will ensure
that no material is catapulted off the tile, resulting
in accidents or injuries.
9. Maintenance
Remove dust and dirt regularly from the
machine. Cleaning is best done with
compressed air or a rag.
Never use caustic agents to clean plastic parts.
8
13:28 Uhr Seite 8

10. Ordering replacement parts

Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required