Giatsu VIOLET UV GIA-S09VIOUV Manual De Usuario página 36

〖Remote Controller Display〗
Signal Emission Symbol
It appears when control
signal is emitted.
Setting temp Display
Displayed the setting
temperature.
Timer Display
Display hour when setting
timer.
also can display the
temperature when setting
I FEEL function
On/Off Timer Display
The ON/OFF symbol will display
when setting the timer.
UVC Display
It appears when UVC
function is set.
Sleep Mode Display
Displayed when Pressing
"Sleep" button, the unit will
run in sleep mode.
Instruction for remote controller
The remote controller uses two AAA batteries under normal condition, the batteries last

for about 6 months. Please use two new batteries of similar type (pay attention to the poles in
installing)
When using remote controller, please point the signal emitter towards indoor unit receiver;

There should be no obstacle between remote controller and indoor unit.
Pressing two buttons simultaneously will result wrong operation.

Do not use wireless equipment (such as mobile phone) near indoor unit. If interference occurs

because of this, please switch off the unit, pull out power plug, then plug again and switch on
after a while.
There is no direct sunlight to the indoor receiver, or it can not receive the signal from the remote

controller.
Don' t cast the remote controller.

Don' t put the remote controller under the sunlight or near the oven.

Don' t sprinkle water or juice on the remote controller, use soft cloth for cleaning if it occurs.

The batteries must be removed from the appliance before it is scrapped and that they are

disposed of safety.
USER'S MANUAL
Turbo Display
It appears when turbo function
is set in COOLING or HEAT
mode, and will flash.
Horizontal Swing
Display
Displayed when Pressing
"H-SWEEP button.
34
Operating Mode
Selection Display
AUTO
HEAT
COOL
DRY
SWEEP
Wind Speed Selection
Display
Auto
High speed
Medium speed
Low speed
Quiet speed
Vertical
Swing Display
Displayed in according with
vertic
al blades position and
swing or not.
Lock Display
Displayed when Pressing
"LOCK" button.