Technical Specifications; Installation; Installing The Aqualink Tri® Control Box - Zodiac AquaLink TRi Manual De Instalación Y De Uso

Cable gland*
*Use the supplied cable glands to pass all the wires inside the control box in order to maintain the
protection index. Remove the removable caps from the metal base of the AquaLink TRi® control box to
insert the cable glands.
1.3 Technical specifications
AquaLink TRi® control box
Size (l x h x d)
Weight (complete appliance)
Protection index
Power supply
Consumption
Relay specifications
Relay power equivalences
2. Installation
2.1 Installing the AquaLink TRi® control box
 The AquaLink TRi® control box is ideally located in a technical room or outside in a sheltered location, and is
imperatively close to the pool equipment to be controlled, and sheltered from frost, and easily accessible at any
time,
 it must be installed at a minimum distance from the edge of the pool in order to avoid any projections of spray
onto the appliance. This distance is determined by the electric standards applicable locally
(In France: 3.5 metres)
 It must be installed on a level, ideally at 1.5 metres from the ground,
 use the control box fixture support to drill 4 holes in the wall,
 fix the support using the supplied plugs and screws (see §1.2),
 open the control box cover (2 screws on the right side) and drill the hole in the side of the control box (see
diagram below).
 place the control box and screw it onto the support using the supplied "M5" type screws.
 close the control box cover.
"M5" screws
H0369400.B.EN – 2013/03
Plastic cover + metal
support for offsetting
the user interface
36.5 x 30.5 x 13.5 cm
3.5 kg
IPX5
220‐240 V AC / 50 Hz
200 W / 0.9 A
0 – 240 V AC / 25 A
per relay
3 HP / 1500 W
RJ11 cable extension
for offsetting the user
interface (5 metres)
iAquaLink™ antenna box
Size (h x l; excluding
the antenna)
Power supply
Web connection
WiFi network
specifications
AquaLink TRi® control box
Hardware for the
Air temperature
AquaLink TRi®
sensor fixing clip
control box
15.0 x 10.5 cm
RS485
10 V DC, 180 mA
WiFi or wired (Ethernet RJ45)
802.11b
Open or secure, WEP or WPA
encryption
Wall fixture support
and hardware
3