PUMP OPERATING MODES
The IntelliFlo
VSF Variable Speed and Flow Pump can be programmed in three different modes:
®
Programs 1-4 can be programmed in all three modes.
Programs 5-8 can only be programmed in Schedule mode since there are no buttons on the control panel for
Programs 5-8. The default setting for Programs 5-8 is "Disabled".
Program 1-4
Program 5-8
Manual
Assigns a speed or flow to one of the four Program buttons on the control panel. This mode can only be used for
programs 1-4. Programs 1 and 2 are Manual by default.
To operate in Manual mode, press one of the four program buttons and then press the Start/Stop button. The
pump will run the assigned speed or flow assigned to that program button.
Egg Timer
Programs 1-4 can be programmed to run at a certain speed or flow and for a duration of time once a program
button is pressed.
Programs 3 and 4 are Egg Timers by default. If you desire a different method of operation, programs 3 and 4 can
be changed to Manual mode in the control menu.
To operate in Egg Timer mode, press a program button and then press Start/Stop. The pump will run that setting
for the set amount of time and then turn off.
Schedule
Programs 1-8 start and stop at a specific time during a 24 hour period. Speeds or flows programmed in Schedule
mode will override any manually selected speed or flow once the next Schedule command commences.
Program Types
This pump can run saved programs at either constant speeds or constant flow rates. This gives the user the ability
to precisely assign the output from the pump so that no energy is wasted and the job is completed accurately.
P-QSG-VSF - Rev.November 2017
Manual
Set Type
Schedule
Set Type
Set Start Time
Set Stop Time
Egg Timer
Set Type
Set Duration
Disabled
Default: Disabled
Set Type
Schedule
Set Start Time
Set Stop Time
Program Menu Tree Options
INTELLIFLO VSF - QUICK START GUIDE
Set Speed
Set Flow
Set Flow
Set Speed
Set Flow
Set Flow
Set Speed
Set Flow
Set Flow
Set Speed
Set Flow
Set Flow
9