STA-RITE DP233110V-01 Manual De Instrucciones página 3

General Safety / Assembly
14. Protect electrical cord from sharp objects, hot surfaces,
oil, and chemicals. Avoid kinking cord. Replace or
repair damaged or worn cords immediately.
15. Do not touch an operating motor. Modern motors are
designed to operate at high temperatures.
Risk of electric shock. If your basement has
water or moisture on the floor, do not walk on wet area
until all power has been turned off. If shut-off box is in
basement, call electric company or hydro authority to shut-off service to house, or call your local fire department
for instructions. Remove and replace system. Failure to fol-
low this warning can result in fatal electrical shock.
Risk of electric shock. Do not handle pump
or pump motor with wet hands or when standing on wet
or damp surface, or in water. Always disconnect the pump
and switch from the electrical power source before doing
any maintenance.
16. Pump water only with this pump.
ASSEMBLY
Steps 1 and 2 (See Figure 1)
2
Figure 1
Step 3 (See Figure 2)
3
Figure 2
1
Step 4 (See Figure 3)
Install the discharge pipe hand-tight plus one-half turn.
4
Figure 3
Step 5 (See Figure 4)
Place the pump in the basin as shown. Align the discharge
with one of the threaded ports in the cover.
1
1 " NPT
2
Discharge
Inlet
Figure 4
Step 6 (See Figure 5)
Turn the cover upside down and 'lay in' the basin gasket
as shown.
Locating
Cleats
Figure 5
1
1 " NPT
2
Vent
Pump
Basin
3