Cleaning; Danger Of Fire - CASO DESIGN EMCG 32 Manual De Instrucciones

14.2 Cleaning

 Cooking chamber and inside of door

Danger of fire

► Always remove grease residues in the device, as these residues can otherwise
ignite.
 Keep the cooking chamber of the oven clean. Wipe off any spattered or spilt food from
the walls of the cooking chamber with a damp cloth.
If the oven is excessively dirty, you can use a mild cleaning agent.
 Wipe the door, window and the door gaskets with a damp cloth, to remove any spatters
and spilt food. Residues on the door gasket can mean that the door does not close
properly any more, which will cause the microwaves to escape.
 Wipe off any steam, which has settled on the oven door, with a soft cloth. This may be
the case if the device is used in an extremely damp environment and is normal.
 Smells can be removed from the oven by mixing a cup of water with the juice and the
skin of a lemon, pouring this into a deep microwave-proof bowl and allowing it to cook in
Microwave mode for five minutes. Then, dry off the oven thoroughly with a soft cloth.
 After cleaning the interior space, leave the oven door open until the interior of the device
is completely dry.
 Cleaning hint – If there are cooked food residues stuck to the inside walls of the oven,
there is an easy way to clean these: Place half a lemon into bowl, add 300 ml water and
microwave this for 10 minutes at full power. Then simply wipe the inside of the
appliance clean with a soft and dry cloth.
 Front of device and operating panel
 Clean the front of the device and the operating panel with a soft, slightly damp cloth.
 Please bear in mind that the operating panel does not get wet. Use a soft, damp cloth
for cleaning.
Please note
► Leave the oven door open to prevent the device from being re-started accidentally.
 Exterior housing
 Clean the exterior surfaces of the device with a damp cloth.
 Turntable, grating and rolling ring
 The accessories (turntable, grating and rolling ring) must occasionally be removed and
cleaned. Wash the accessories in warm soapy water.
 The rolling ring should be cleaned regularly to prevent excessive noise development or
a rotational malfunctions.
The rolling ring can be washed in a mild soapy solution . Please remember to put the
rolling ring back again properly after cleaning it.
caso EMCG 32 70