Inserting Batteries Into The Remote Control; Demo Function - Panasonic SC-PM45 Instrucciones De Funcionamiento

Optional antenna connections Optional antenna connections
FM outdoor antenna
FM outdoor antenna
• Never use an outdoor antenna during a lightning storm.
• You can connect the FM outdoor antenna for better reception. Please consult your dealer for installation.
• Disconnect the FM indoor antenna if an FM outdoor antenna is installed.
• Connect the AM outdoor antenna without removing the AM loop antenna. Run 5 to 12 m of vinyl-covered wire horizontally
along a window or other convenient location.
Step 2 Step 2

- Inserting batteries into the remote control

- Inserting batteries into the remote control
Step 3 Step 3

- DEMO function

- DEMO function
(not included)
75 Ω
coaxial cable
(not included)
■ Batteries
• Insert so the poles (+ and –) match those in the remote control.
• Remove if the remote control is not going to be used for a long period of
time. Store in a cool, dark place.
• Do not use rechargeable type batteries.
• Mishandling of batteries in the remote control can cause electrolyte
leakage, which may cause a fi re.
Do not:
• mix old and new batteries;
• use different types of batteries at the same time;
• heat or expose to fl ame;
• take apart or short-circuit;
• attempt to recharge alkaline or manganese batteries;
• use batteries if their covering has been peeled off.
■ Use
Aim at the remote control sensor, avoiding obstacles, at a maximum
range of 7 m directly in front of the unit.
Refer to page 6 for remote control signal sensor position.
When the unit is fi rst plugged in, a demonstration of its functions may be
shown on the display.
If the demo setting is off, you can show a demonstration by selecting
"DEMO ON".
Press and hold [7, –DEMO].
The display changes each time the button is held down.
While in standby mode, select "DEMO OFF" to reduce power
consumption.
AM outdoor antenna
AM outdoor antenna
(not included)
AM loop antenna
(included)
5
5