Remove / Replace The Refrigerator; Remove The Refrigerator; Replace The Refrigerator - Norcold N180.3 Manual De Servicio

Tabla de contenido

Remove / Replace the Refrigerator

The rear of the refrigerator has sharp
CAUTION
!
edges and corners. To prevent cuts
or abrasions when working on the
refrigerator, be careful and wear cut
resistant gloves.

Remove the Refrigerator

1. Close the valve at the propane gas tanks(s) of the vehicle.
2. Remove the screws which attach the front of the refrigerator to
the enclosure.
To avoid possible propane gas leaks,
WARNING
!
always use two (2) wrenches to loosen
ATTENTION
and tighten the propane gas supply lines
at the refrigerator's manual shut off valve.
3. Move the refrigerator forward enough to disconnect the propane
gas supply line from the manual shut off valve, located on top of
the refrigerator.
4. Unplug the AC power cord from the receptacle.
5. Remove the DC wiring from the refrigerator.
■ Put a mark on the DC wires so that you can put them back
in the correct location.
6. Remove the refrigerator from the enclosure.

Replace the Refrigerator

WARNING
Make sure the combustion seal is
!
not broken, is completely around the
ATTENTION
refrigerator mounting flanges, and is
between the mounting flanges and the
wall of the enclosure. If the combustion
seal is not complete, exhaust fumes can
be present in the living area of the vehicle.
The breathing of exhaust fumes can
cause dizziness, nausea, and in extreme
cases, death.
1. Push the refrigerator partly into the enclosure.
2. Connect the DC wiring to the refrigerator.
3. Push the AC power cord into the receptacle.
To avoid possible propane gas leaks,
WARNING
!
always use two (2) wrenches to loosen
ATTENTION
and tighten the propane gas supply lines
at the refrigerator's manual shut off valve.
4. Attach the propane gas supply line to the 3/8 inch male flare
fitting of the refrigerator.
Do not allow the leak checking solution to
WARNING
!
touch the electrical components. Many
ATTENTION
liquids are electrically conductive and can
cause a shock hazard, electrical shorts,
and in some cases, fire.
5. Using a leak checking solution, examine the gas supply line
connections for leaks. No leaks are allowed.
6. Push the refrigerator fully into the enclosure.
7. Put the screws through the mounting flange and into the wall.
8. Open the valve of the propane gas tank(s) of the vehicle
www.norcold.com
19
SERVICE MANUAL

Capítulos

Tabla de contenido
loading

Tabla de contenido