Delta 50-786 Manual De Instrucciones página 9

ATTACH FRONT PANEL TO
BASE (FIg. 12–15)
1. P lace 5/16" lock washer (K) on 5/16" x 3/4" (19 mm)
hex head bolt (L).
2. Line up holes in front panel (N) with holes in base
plate (S), as shown in Figure 12.
NOTE: Be sure front panel is oriented as shown in
Figure 13.
3. P lace hex head bolt and washer assembly through
holes in front panel (N) and base plate (S).
4. From underneath the base secure front panel to
base using a 5/16" hex nut (Q).
5. Repeat for other hole in front panel and base.
6. T he front and side panels are shown correctly
assembled in Figure 15.
NOTE: FASTEN ALL HARDWARE HAND TIGHT ONLY AT
THIS POINT. Hardware will be tightened later in a certain
order.
ATTACH MOTOR/BLOWER
TO STAND (FIg. 16, 17)
1. P lace motor/blower housing on top of stand. Align
holes (T) in the housing with holes (U) in the stand.
2. P lace 5/16" lock washer (K) on 5/16" x 3/4" (19 mm)
hex head bolt (L).
3. Insert this washer/bolt assembly up through holes
(U) in stand and insert bolt into the threaded holes
(T) of the motor/blower housing. Hand tighten only.
4. Repeat for five remaining holes.
NOTE: FASTEN ALL HARDWARE HAND TIGHT ONLY AT
THIS POINT. Hardware will be tightened later in a certain
order.
FIg. 15
FIg. 13
FIg. 16
L
FIg. 17
9
N
K
L
S
FIg. 12
Q
FIg. 14
T
U
K