Delta 50-786 Manual De Instrucciones página 8

ATTACH SIDE PANELS TO BASE (FIg. 5–8)
1. P lace 5/16" lock washer (K) on 5/16" x 3/4" (19 mm)
hex head bolt (L).
2. Line up holes (M) in side panel (N) with holes (O) in
base plate.
NOTE: Be sure side panel is oriented as shown in
Figure 6.
3. P lace hex head bolt and washer assembly through
hole (M) in the side panel and and hole (O) in base.
4. From underneath the base secure side panel to
base using a 5/16" hex nut (Q).
5. Repeat for other hole in side panel and base.
6. R epeat above steps for the other side panel. The
two panels are shown correctly assembled in
Figure 8.
NOTE: FASTEN ALL HARDWARE HAND TIGHT ONLY AT
THIS POINT. Hardware will be tightened later in a certain
order.
ATTACH CROSS PANELS TO
SIDE PANELS (FIg. 9, 10)
1. P lace 5/16" lock washer (K) (inset) on a 5/16" x 3/4"
(19 mm) hex head bolt (L).
2. Line up four holes of cross panel (R) with four lower
holes in side panels (N).
3. Insert hex head bolt and washer assembly - (L) and
(K) (inset) - through holes in side panels (N) and then
through holes in cross panel (R).
4. A ttach cross panel to side panel using 5/16" hex nut
(Q).
5. Assembled cross panel is shown in Figure 11.
6. A ssemble top cross panel in the same manner at
holes (SS).
NOTE: FASTEN ALL HARDWARE HAND TIGHT ONLY AT
THIS POINT. Hardware will be tightened later in a certain
order.
N
K
FIg. 9
R
N
L
FIg. 5
N
M
O
FIg. 5
FIg. 6
FIg. 8
Q
FIg. 10
8
L
K
M
O
Q
FIg. 7
SS
SS
FIg. 11