Panasonic EY7840 Manual De Instrucciones página 9

. OPERATION
Forward/Reverse Lever
Forward
Lock
Be sure to set the lever in the center
to lock it after use.
Operate the Forward/Reverse lever
after the motor rotation is completely
stopped.
Hammering/Drilling Switching Lever
NOTE: Operate the mode change after
the motor rotation is completely
stopped.
Position of
Action mode
switching lever
Rotation with
hammering
Rotation only
Clutch Torque Setting
Adjust the torque to one of the 5 clutch
set tings or " " position.
CAUTION:
Test the setting before actual operation.
Set the scale at this mark (
Variable Speed Control Trigger
Reverse Control Panel
(1) LED light
Operation
Concrete
Drilling,
Block Drilling
Screw
Fastening,
Drilling
).
Use of controls or adjustments or perform-
ance of procedures other than those speci-
fi ed herein may result in hazardous radiation
exposure.
- 9 -
To set the center of a hole, pull the
trigger slightly to start the drill rotation
slowly.
The more the speed control trigger is
pulled, the higher the speed becomes.
(1)
Pressing
LED light on and off.
The light illuminates with
very low current, and it
does not adversely af-
fect the performance of
the driver during use or its
battery capacity.
CAUTION:
• The built-in LED light is designed to
illuminate the small work area tem-
porarily.
• Do not use it as a substitute for a
regular flashlight, since it does not
have enough brightness.
This product has the built-in LED light.
This product is classified into "Class 1
LED Product" to IEC (EN) 60825-1:2001.
LED RADIATION
DO NOT STARE INTO BEAM
CLASS 1 LED PRODUCT
(3)
(2)
toggles the