Bosch AHS 4-16 Instrucciones De Servicio página 10

Product Specification
Hedgecutter
Part number (TYP)
Rated power
No-load stroke rate
Cutting length
Weight
Protection class
Intended Use
The product is intended for cutting and trimming
hedges and bushes in domestic use.
Introduction
This manual gives instructions on the correct as-
sembly and safe use of your hedgecutter. It is impor-
tant that you read these instructions carefully.
Delivered Items
Carefully remove the machine from its packaging
and check for complete contents:
– Hedgecutter
– Blade guard
– Front handle guard
– Two screws
– Operating instructions
When parts are missing or damaged, please contact your
dealer.
Operating Controls
1 Cutting blade
2 Front handle guard
3 Front handle switch levers
4 Rear handle with switch lever
5 Ventilation slots
6 Mains plug**
7 Blade guard
**Country specific
Not all of the accessories illustrated or described are
included as standard delivery.
10 • F016 L70 369 • TMS • 22.11.05
AHS 4-16
3 600 H47 0.. 3 600 H47 1.. 3 600 H47 2.. 3 600 H47 4.. 3 600 H47 5..
[W] 390
[spm] 1 600
[mm] 420
[kg]
2.7
/ II
AHS 42-16 AHS 48-16
420 420
1 600 1 600
420 480
2.7
2.8
/ II / II
Warning! Switch off, remove plug from mains
before adjusting, cleaning or if cable is cut,
damaged or entangled.
The blades continue to move for a few sec-
onds after the hedgecutter is switched off.
Caution! Do not touch the moving blades.
Electrical Safety
Your machine is double insulated for safety and re-
quires no earth connection. The operating voltage is
230 V AC, 50 Hz (for non-EU countries 220 V, 240 V
as applicable). Only use approved extension cables.
Contact your Bosch Service Center for details.
Extension cords/leads should only be used if they
comply with H05VV-F or H05RN-F types.
It is recommended for increased electrical safety to
use a Residual Current Device (RCD) with a tripping
current of not more than 30 mA. Always check your
RCD every time you use it.
For products not sold in GB: WARNING: For
safety, it is essential that the mains plug 6 attached
to the machine is fitted to the power supply cable 9
as shown.
The couplings of connection leads must be pro-
tected against splashes and the coupling sockets on
the leads must be made of rubber or coated with
rubber.
Fixing means for the connection leads must be used.
The connection lead must be inspected for signs of
damage at regular intervals and may only be used if
in perfect condition.
If the supply cord is damaged, it must be replaced by
a Bosch Service Centre.
Products sold in GB only: Your hedecutter is fitted
with an approved 13 A (BS 1363/A) electric plug and
is protected by a 13 A fuse (ASTA Approved to
BS 1362).
If the fitted plug is not suitable for your socket outlets,
it should be cut off and an appropriate plug fitted in its
place by an authorized customer service agent.
The severed plug must be disposed of to avoid a
possible shock hazard and should never be inserted
into a 13 A socket elsewhere.
English - 2
AHS 52-16
420
1 600
520
2.8
/ II
For Your Safety
AHS 63-16 C
420
1 600
630
2.9
/ II