Stihl BGA 85 Manual De Instrucciones página 8

English
Protect the charger from
rain and dampness. Keep
charger dry.
Use and store charger
only indoors in dry rooms.
Operate charger at temperatures
between 41 °F (5 °C) and 104 °F
(40 °C).
Allow the charger to cool down normally
– do not cover it.
Never bridge the contacts of the charger
with metallic objects (e.g. nails, coins,
jewelry) – short circuit. The charger may
be damaged by a short circuit.
In the event of smoke or fire in the
charger, disconnect it from outlet
immediately.
Warning!
To reduce the risk of electric shock or
short circuit, do not insert any objects
into the charger's cooling slots.
Warning!
The charger heats up during the charg-
ing process. Do not operate on an easily
combustible surface (e.g. paper, texiles)
or in an easily combustible environment
– risk of fire.
6
Warning!
Do not operate in a hazardous location,
i.e. in a location where there are com-
bustible liquids (fumes), vapors or
dusts. Chargers can produce sparks,
which may ignite the dust or vapors –
risk of explosion.
Check the charger's
power supply cord and
plug regularly for dam-
age. If the power supply
cord or plug is damaged,
immediately disconnect
the plug from the wall
outlet to avoid the risk of
electric shock.
Never jerk the power supply cord to
disconnect it from the wall outlet. To
unplug, grasp the plug, not the cord.
Have a damaged power supply cord
repaired by an experienced electrician.
Do not use the power supply cord for
any other purpose, e.g. for carrying or
hanging up the charger.
Never use power supply cords that do
not comply with regulations.
Make sure the power supply cord is
located and/or marked so that it will not
be stepped on, tripped over, come in
contact with sharp edges or moving
parts or otherwise be subjected to
damage or stress.
An extension cord should not be used
unless absolutely necessary. If an
extension cord must be used, plug the
charger into a properly wired 16 gauge
(AWG 16) or heavier gauge extension
cord with blades that are the same
number, size and shapes as the blades
on the charger.
To reduce the risk of electric shock:
– Always connect the charger to a
properly installed wall outlet.
– Make sure the insulation of the
power supply cord and plug is in
good condition.
Unplug the power supply cord from the
outlet when charger is not in use.
Never store the battery in the charger.
THE USE OF THE POWER TOOL
Transporting the Unit
Warning!
Always switch off the power tool, move
retaining latch to ƒ and remove the bat-
tery – even when you carry the unit for
short distances. When transporting it in
a vehicle, properly secure the power
tool to prevent turnover and damage.
Remove the battery from
the power tool. This
avoids the risk of the
motor starting
unintentionally.
BGA 85