Light Emitting Diodes (Led) On Charger; Switching On - Stihl BGA 85 Manual De Instrucciones

English
Light Emitting Diodes
(LED) on Charger
1
The light emitting diode lights up green
or flashes red.
Green continuous light ...
... means the following:
The battery
– is being charged
– is too hot and must cool down
before it is charged
See also "Light Emitting Diodes (LED)
on Battery".
The green light emitting diode on the
charger goes off as soon as the battery
is fully charged.
Red flashing light ...
... means the following:
14
– No electrical contact between
battery and charger – remove and
refit the battery
– Faulty battery – see also "Light
Emitting Diodes (LED) on Battery".
– Charger faulty – have checked by a
servicing dealer. STIHL
recommends a STIHL servicing
dealer.

Switching On

The battery is given a charge of about
30% before leaving the factory.
Recommendation: Fully charge the
battery before using your power tool for
the first time.
N
If necessary, remove the cover from
the battery compartment before
fitting the battery, i.e. depress both
locking tabs to unlock and remove
the cover.
Fitting the battery
N Insert the battery (1) in the power
tool – the battery slides into the
compartment – press it down
carefully until it snaps into position –
the battery must be flush with the
top of the housing.
Switching On
N Make sure you have a secure and
balanced footing.
N Stand upright – hold the power tool
in a relaxed position.
1
BGA 85