Tabla de contenido
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
CHECK THESE POINTS TO HELP SAVE YOU TIME AND MONEY.
PROBLEM
SOLUTION
DISHWASHER DOES NOT RUN
DETERGENT REMAINS IN THE
DISPENSER OR
TABLET IS ON BOTTOM
OF TUB
CYCLE RUNS TOO LONG
DISHWASHER NOT DRYING
WILL NOT FILL
WATER REMAINS IN THE TUB/
WILL NOT DRAIN
NOTE: It is normal for the dishwasher to repeatedly
pause several times during a cycle.
If the Start/Resume
light is blinking, push START/RESUME and close the door within 3 seconds.
Be sure the door is closed and latched.
Check that there is not an interference with large casserole dishes and the wash system at the
back of the dishwasher. Adjust loading as necessary to ensure door is closed and latched.
Be sure you have selected a cycle. (See "Cycles and Options
Information.")
Be sure there is power to the dishwasher. A circuit breaker or fuse may have tripped.
If lights other than Start/Resume
blink and the unit will not run, you will need to call for service.
Check for dishware such as cookie sheets, cutting boards, or large containers, etc., that may be
blocking the detergent dispenser from opening properly.
Be sure your detergent is fresh and lump free.
Be sure the cycle has completed
(green light is on). If it has not completed,
you will need to
resume the cycle by pressing START/RESUME and closing the door within 3 seconds.
NOTES.
•
To use less water and reduce energy consumption you will encounter cycles that typically
run
for up to 3 hours.
•
A water heater setting of 120°F (49°C) is best. The dishwasher will delay longer while heating
cooler water.
•
Some options will add time to the cycle. (See "Cycles and Options Information"
section.) The
SmartDry
TM
or Heated Dry option adds 1/2 hour.
Try the 1 Hour Wash cycle.
Run the hot water at a faucet close to the dishwasher before selecting and starting the cycle.
NOTE: Plastic and items with nonstick surfaces are difficult
to dry because they have a porous
surface which tends to collect water droplets. Towel drying may be necessary.
Use of rinse aid along with the SmartDry
TM
or Heated Dry option is needed for proper drying.
Proper loading of items can affect
drying. (See specific loading instructions within this guide.)
Glasses and cups with concave bottoms hold water. This water may spill onto other items when
unloading.
•
Unload the bottom rack first.
•
Locate these items on the more slanted side of the rack for improved
results.
Be sure the water is turned on to the dishwasher.
Check that the float is free from obstructions.
(See "Parts and Features.")
Check for suds in the dishwasher. If foam or suds are detected, the dishwasher may not operate
properly or may not fill with water.
Be sure the cycle has completed
(the green light is on). If it has not, you will need to resume the
cycle by pressing START/RESUME and closing the door within 3 seconds.
If dishwasher is connected to a food waste disposer, be sure the knockout plug has been
removed from the disposer inlet.
Check for kinks in the drain hose.
Check for food obstructions in the drain or disposer.
Check your house fuse or circuit breaker.
23
Tabla de contenido
