When The Work Is Done - Siemens VS07 Serie Instrucciones De Uso

en
11*
Figure
To clean, switch the autofloor tool to the hard floor
setting and simply vacuum using the suction
pipe/telescopic tube.
Turbo brush
If your vacuum cleaner is equipped with a turbo brush,
please consult the accompanying instruction manual for
notes on its use and maintenance.
12*
Figure
Vacuuming with accessories
(attach to handle or suction pipe as required).
a) Crevice nozzle
For cleaning crevices and corners.
b) Upholstery nozzle
For cleaning upholstered furniture,
curtains, etc.
c) Hard furnishings brush
For vacuuming picture frames, books, furniture requiring
particular care, etc.
13
Figure
Other accessories that you do not need can be stored
easily in the accessories compartment of the vacuum
cleaner lid.
14*
Figure
Pet hair tool
Floor tool for easy and thorough vacuuming of pet hair.
Push the telescopic tube into the connecting piece of the
pet hair tool until it engages.
Press on the locking collar and pull out the telescopic
tube to disconnect.
To clean, simply vacuum the tool using the suction
pipe/telescopic tube.
15*
Figure
Hard-floor brush
For cleaning hard floor coverings
(tiles, parquet flooring, etc.)
Connect the floor tool and the telescopic tube together.
16
Figure
Once you have switched off the vacuum cleaner, you can
use the parking aid on the back of the vacuum cleaner if
you wish to stop vacuuming for a short time.
To do this, slide the catch on the floor tool into the
groove on the back of the vacuum cleaner.
* Dependent on model
10

When the work is done

17
Figure
Unplug the vacuum cleaner.
Briefly pull the power cord and release. The cord rewinds
automatically.
18
Figure To store or transport the vacuum cleaner, use the storage
aid on the underside of the vacuum cleaner.
Stand the vacuum cleaner up on its end. Slide the catch
on the floor tool into the groove on the underside of the
vacuum cleaner.
Changing the dust bag and filters
Replacing the dust bag
19
Figure
If the dust bag change indicator is completely yellow
when the floor tool is lifted from the floor and the highest
suction power is selected, the dust bag must be
changed, even though it may not yet be full. In this case
it is essential to change the dust bag due to the type of
material it contains.
First check that the nozzle, suction pipe and flexible hose
are not blocked, as this would also lead to the dust bag
change indicator being triggered.
20
Figure
Open the lid by moving the locking lever in the direction
of the arrow.
21
Figure
a) Seal the dust bag by pulling the sealing strip and then
remove it.
b) Insert a new dust bag into the holder and close the dust
bag compartment lid.
Caution: the lid will only close when the dust bag is
!
inserted.
Cleaning the motor protection filter
The motor protection filter should be cleaned regularly by
knocking out the dirt and rinsing.
22
Figure
Open the dust bag compartment lid (see Figure 20).
Pull out the motor protection filter in the direction of the
arrow.
Clean the motor protection filter by tapping it.
If it is very dirty, the motor protection filter should be
rinsed.
The filter must then be left to dry for at least 24 hours.
After cleaning, slide the motor protection filter into the
vacuum cleaner and close the dust bag compartment lid.