Torque Limiter - Makita DHR242 Manual De Instrucciones

• Do not turn the knob forcibly. Forcing the knob
may cause tool damage.
When turning the action mode changing knob from
the symbol to the
knob may no longer move in the
tion. In this case, move the knob to the
position and run the tool few seconds. After that,
move the knob to the desired position.
symbol or vise versa, the
symbol posi-
symbol

Torque limiter

The torque limiter will actuate when a certain torque
level is reached. The motor will disengage from the out-
put shaft. When this happens, the bit will stop turning.
CAUTION:
• As soon as the torque limiter actuates, switch
off the tool immediately. This will help prevent
premature wear of the tool.
• Hole saws cannot be used with this tool. They
tend to pinch or catch easily in the hole. This
will cause the torque limiter to actuate too
frequently.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
the battery cartridge is removed before carrying
out any work on the tool.
Side grip (auxiliary handle)
1
3
► 1. Protrusion 2. Groove 3. Loosen 4. Tighten 5. Side
grip
CAUTION:
• Always use the side grip to ensure operating
safety.
Install the side grip so that the protrusion on the grip fit
in between the grooves in the tool barrel. Then tighten
the grip by turning clockwise at the desired position. It
may be swung 360° so as to be secured at any position.
Bit grease
Coat the bit shank head beforehand with a small
amount of bit grease (about 0.5 -1 g; 0.02 - 0.04 oz.).
This chuck lubrication assures smooth action and lon-
ger service life.
8 ENGLISH
2
4
5