Remote Control (Optional) - Palazzetti ECOMONOBLOCCO WT F Serie Manual De Uso

21

Remote control (optional)

21.1 Overview
This device allows you to remotely control the operating
parameters of the Ecomonoblocco.
21.2 Pairing at the control panel
Access the screen Info on the control panel display and
navigate on the screen
Remote: scanning.
Insert the batteries in the remote control
After few seconds the display will change screen, you
will be presented with the following information and the
remote control will be properly paired to the control panel:
Remote: connected! Remote paired to the control panel
Temp [*C]: 26.0 Room temperature detected by the
remote control
Hu [perc]: 34.5 Percentage of humidity detected by the
remote control
Pr [mBar]: 1000 Atmospheric pressure detected by the
remote control
It may be necessary to perform this procedure again in
case the remote control remains outside of the range of
the signal for a long time.
21.3 Keys
1: Switch On / Off (press and hold for about 3 seconds
to perform the desired operation)
2: Key momentarily not enabled
3: Power
4: Ventilation
5: Door opening (where provided)
6: Key momentarily not enabled
7 and 8: Keys to set the parameters
21.4 Changing the power
a) Press the key 3 which will light up
b) Press the keys 7 and/or 8 to set the desired value
21.5 Changing the ventilation
a) Press the key 4 which will light up
b) Press the keys 7 and/or 8 to set the desired value
21.6 Door opening/closing (where provided)
a) Press the key 5 which will light up
b) Press the buttons 7 and/or 8 to open / close the door
cod. 004777530 MBL - 21/03/2019 - Palazzetti - PN - Italy
1
C
3
5
7
AAA 1,5 V - 2x
2
4
6
8
35