Operating And Display Elements; Installation And Connection - Dometic GROUP WAECO CoolMatic CS-MP2 Instrucciones De Montaje

_CS-ACT-MP2.book Seite 20 Freitag, 15. Oktober 2010 10:55 10

Installation and connection

5.2

Operating and display elements

No. in
fig. c, Description
page 5
1 Temperature
controller
6 Installation and connection
The cooler is installed in the drawer under the bed.
➤ Lift the mattress.
➤ Unscrew the four screws (fig. 1, page 3) and take off the board.
➤ Pull out the drawer and take out the container (fig. 2, page 3).
After you fit the cooler, you can put the container back in.
Note
If you cannot fully pull out the drawer, this is how to release it:
➤ Remove the screws (fig. 3 1, page 3) and unplug the panel beside the
drawer (fig. 3 2, page 3).
➤ Have the supply cable from slot X 7 (fig. 4, page 3) to the cooler laid by
a specialist Mercedes Benz garage.
➤ Cut out a section for ventilation at the appropriate position on the panel
(fig. 5, page 3)
➤ Push on the plate nuts supplied (fig. 6, page 3 and fig. 7, page 4)
➤ Feed the connection cable for the cooler through the hole provided.
(fig. 8, page 4)
➤ Fasten the cooler with the screws provided at the appropriate positions
(fig. 9, page 4).
➤ Fasten the cooler cable to the position marked on the drawer using the
clip provided and place the rubber in the appropriate position (fig. 0,
page 4).
20
Explanation
– Switches the cooler on or off
– Adjusts the temperature
CoolMatic CS-MP2