Stihl Cutquik TS 700 Manual De Instrucciones página 9

English / USA
They are not suitable for cutting metal or
other materials.
Wet or dry cutting is possible. With wet
cutting your diamond wheel will have a
longer life. Water attachments are
included with your STIHL cut-off
machine. See the appropriate section of
your owner's manual.
!
Warning!
Do not remount a used diamond
abrasive wheel without first inspecting
for under-cutting, flatness, core fatigue,
segment damage or loss, signs of
overheating (discoloration) and possible
arbor hole damage.
Check the wheel for cracks and make
sure that no pieces have broken off the
wheel before use.
Always fit the wheel so that the arrow on
the wheel points in the direction of the
rotation of the spindle.
8
THE USE OF THE CUT-OFF
MACHINE
Transporting the STIHL Cutquik
!
Warning!
Always stop the engine before putting a
cut-off machine down or carrying it. The
abrasive wheel continues to rotate for a
short while after the throttle trigger is
released (flywheel effect). Carrying a
cut-off machine with the engine running
is extremely dangerous. Accidental
acceleration of the engine can cause the
wheel to rotate. Avoid touching the hot
muffler.
By hand: When carrying your cut-off
machine by hand, the engine must be
stopped and the cut-off machine must
be in the proper position. Grip the front
handle and place the muffler at the side
away from the body.
!
Warning!
Always protect the cutting wheel from
hitting the ground or any other objects.
Damaged wheels may shatter and
cause serious or fatal injury.
By vehicle: Properly secure your cut-off
machine to prevent turnover, fuel
spillage and damage to the cut-off
machine. Never transport with cutting
wheel mounted. A wheel damaged
during transportation may shatter during
operation and cause serious personal
injury.
Preparation for the Use of the Cut-Off
Machine
For assembly, follow the procedure
described in the appropriate section of
your owner's manual.
Keep the handles dry, clean and free of
oil and fuel.
Before operation of your cut-off
machine, be sure the controls (e.g.
throttle trigger, stop switch) and the
safety devices are working properly, the
carburetor idle and maximum speed are
correctly adjusted, the wheel is properly
mounted, and the wheel guard is in
place and securely fastened to your unit.
All wheels should be carefully inspected
for good condition before mounting.
TS 700