Stihl Cutquik TS 700 Manual De Instrucciones página 35

English / USA
7
: Lever the rope out of the starter
handle with a screwdriver.
: Remove the remainder of the rope
from the rotor and starter handle.
:
Thread a new ElastoStart starter
rope from top to bottom through the
handle and rope guide bush (7).
:
Thread the rope through the rotor
and secure it in the rotor with a
simple overhand knot.
34
: Slip the rope rotor on the starter
post and turn it back and forth a little
until
: the anchor loop of the rewind spring
engages.
:
Refit the pawls (6) in the rope rotor.
:
Place the washer (5) on the starter
post.
:
Press the spring clip (4) onto the
starter post and over the pegs of the
pawl with a screwdriver or suitable
pliers.
The spring clip must point to the left,
in anticlockwise direction – as
illustrated.
Tensioning the rewind spring
: Make a loop in the unwound starter
rope and use it to turn the rope rotor
six full revolutions in the direction of
the arrow.
:
Hold the rope rotor tight:
pull out the twisted rope and
untangle it.
:
Release the rope rotor.
:
Slowly let go of rope so that it winds
onto the rotor.
The starter grip must be drawn firmly
into the rope guide bush. If it tips
sideways: increase the spring tension by
another turn.
TS 700