Getting Ready To Build - Dremel 3D40 FLEX Instrucciones De Funcionamiento Y Seguridad

DM 2610039151 10-18.qxp_3D40 10/8/18 10:34 AM Page 25
instructions when using the Dremel 3D40.
Failure to do so may result in fire, equipment
damage, property damage or personal injury.
operation or until it has cooled down to at
least 60°C (140°F). Contact with the extruder
tip during or after operation before tip has
cooled may result in personal injury.
filament not authorized by Dremel may result
in equipment and property damage.
may damage the extruder.
LOADING/CHANGING FILAMENT
1. Start filament load/change process by
tapping "Filament" button on touch screen.
Extruder will move to front right corner of
print area and extruder tip will begin to
FIG. 8
Open

Getting Ready to Build

Observe all provided
warnings and safety
Do not touch the
extruder tip during
Use only DREMEL
filament. Use of
Do not pull the
filament out. Doing so
Spool
Holder
Close
heat.
2. After extruder stops moving, open the
3D40 Lid for better access to extruder.
3. If existing filament is loaded, cut existing
filament near extruder intake and tap
"Next" button on touch screen.
4. Remove Spool door by rotating it counter
clockwise and remove existing spool if
one is present, see figure 8.
Filament
Filament
Guide Tube
25