Getting Ready To Build - Dremel 3D40 FLEX Traducción De Las Instrucciones Originales

GETTING READY TO BUILD

OBSERVE ALL PROVIDED
WARNING
!
WARNINGS AND SAFETY
INSTRUCTIONS WHEN USING THE DREMEL 3D40
FLEX. Failure to do so may result in fire, equipment
damage, property damage or personal injury.
DO NOT TOUCH THE EXTRUDER
WARNING
!
TIP DURING OPERATION OR
UNTIL IT HAS COOLED DOWN TO AT LEAST 60°C
(140°F). Contact with the extruder tip during or after
operation before tip has cooled may result in
personal injury.
USE ONLY DREMEL FILAMENT.
WARNING
!
Use of filament not authorized by
Dremel may result in equipment and property
damage.
DO NOT PULL THE FILAMENT
WARNING
!
OUT. Doing so may damage the
extruder.
LOADING/CHANGING FILAMENT
1. Start filament load/change process by tapping
"Filament" button on touchscreen. Extruder will
move to front right corner of print area and extruder
tip will begin to heat.
FIG. 1
Open
2. After extruder stops moving, open the 3D40 FLEX
3. If existing filament is loaded, cut existing filament
4. Remove Spool door by rotating it counter clockwise
Spool Holder
Filament
Close
18
Lid for better access to extruder.
near extruder intake and tap "Next" button on
touchscreen.
and remove existing spool if one is present, see
figure1.
Filament Guide Tube
5
6
7