Dremel 3D40 FLEX Instrucciones De Funcionamiento Y Seguridad página 9

DM 2610039151 10-18.qxp_3D40 10/8/18 10:34 AM Page 9
Extruder Fan Baffle
Extruder Intake
Extruder Lever
Extruder Tip
Filament
Filament Guide Tube
Filament Jam Sensor
Filament Runout Sensor
Filament Spool
.g, .gcode, .g3drem
Leveling Knobs
Leveling Sensor
Lid
Needle Nose Pliers
OBJ File
Object Removal Tool
PLA
Spool Holder
Spool Door
Stepper Motor
.STL File
Touch Screen
USB Flash Drive
Glossary of Terms
A plastic piece that directs air from the extruder fan onto the build plate to assist in
cooling the active build.
An opening located at the top of the extruder where filament is inserted for building.
A lever located on the side of the extruder that is used to loosen the grip of the
extruder gear motor.
A nozzle located at the bottom of the extruder where heated filament is forced out for
building.
A threadlike strand of plastic material.
A plastic piece that guides the filament from the filament spool through a passage in
the outer housing of your Dremel 3D40.
A sensor in the extruder that pauses your printer if filament stops extruding properly.
A sensor in the extruder intake that pauses your printer if it runs out of filament
during a build.
A cylindrical piece on which a long strand of filament is wound for storage and continuous use.
A buildable file format compatible with your Dremel 3D40.
Knobs located under the build platform base that are used to create proper spacing
between the extruder tip and the build plate.
A sensor that detects the height of the build platform and assists in proper leveling.
Your Dremel 3D40 has a pivoting lid on the top. This allows for more access to the
build plate, extruder, filament, and objects when necessary.
Common tool used to hold small objects and to grab excess material that may be too
hot to touch directly.
A common digital file format used in a wide range of 3D model software. This file is
created in 3rd party 3D software or downloaded.
A tool used to separate your objects from the build plate.
A bioplastic derived from renewable resources such as corn starch.
A plastic piece located to the left of the build plate inside your Dremel 3D40 build area
that is designed to hold a filament spool.
A removable door which locks the filament spool to the spool holder.
A brushless DC electric motor used to drive the guide rails and extruder gears.
A common digital file format used in a wide range of 3D model software. This file is
created in 3rd party 3D software or downloaded.
Full color display that is touch activated. It allows you to monitor your Dremel 3D40
and objects while also providing commands directly to your Dremel 3D40 without the
use of a computer.
A portable memory card used on a wide array of devices.
9