Frequently Asked Questions - Speck Badu Stream II Manual De Instalación

5

Frequently Asked Questions

How is the current generated?
The pump generates up to 400 GPM coming out of two (2) jet nozzles at 27 ft. per second and 36 ft. per second thru one (1)
nozzle creating a swim current in excess of 5700 GPM, measured 6 ft. from the jet.
What size pool do I need?
The BaduStream can be installed in any size pool. However, we recommend a minimum length of 14 ft. and a minimum width
of a 7 ft. swimming lane.
What size plumbing is necessary? How far away from the BaduStream can the pump be installed?
Use 4" plumbing up to 30 ft. For runs longer that 30 ft. use 6" plumbing. The pump should be placed as close to the BaduStream
as local codes will allow. See plumbing installation on page 8 for more details.
How many amps does the pump operate at?
4.0 HP: Maximum 21.0 - 19.4 amps @ 208-230 V
3.5 HP: Maximum 15.2 - 14.0 amps @ 208-230 V
What size breaker do I need?
You must use a 40 amp breaker for the 4 HP pump or 30 amp breaker for the 3 HP pump to avoid nuisance tripping.
Is the BaduStream approved?
Yes. The BaduStream swim jet system is listed by MET, UL and complies with UL standard 1563 Swimming Pool Equipment,
ASME standard ANSI/ASME A112.19.8 (ANSI/APSP-16, 2011) Standard for Swim Jet Combination Fittings, and is VGB 2008
compliant.
Do the covers come in different colors?
Yes. The round covers can be ordered in gray or black. The square cover is only available in black or white.
Does the air regulator come in different colors?
Yes. The air regulator can be ordered in black.
Does it matter if the housing is installed higher or lower than the manual states?
Yes, the center of the jet must be 12" BELOW estimated water level for proper performance of unit.
Can the air regulator be placed elsewhere?
Yes, as long as it is not continuously flooded with water.
Can the pump be placed below water level?
Yes. However, for best performance we recommend ordering a pump for flooded suction (Model 21-80/33G) instead of self-
priming (Model 21-80/33GS). We recommend installing valves for ease of maintenance.
How far away can the air button function properly?
A maximum of 50 ft. from the control box. Consult factory for distances over 50 ft.
Do I need to install a motor starter?
In most case, no. All single phase pumps have built-in thermal overloads. Also, the three phase Model 21-80/33 has built-in
thermal overload. Other three phase pumps require a motor starter.
Should this be tied into my filter system?
No. The swim jet system and the filter system should not be plumbed together as they each provide very specific functions.
Can I use with automated controls?
Yes. It comes with the ability to tie into automated control systems or other switching devices.
19