Concrete or Gunite Installation - continued
B.
The air regulator can be located in the tile above the
water level or in the deck. When tiling the pool, adjust
the air regulator location so it is 3"-4" ABOVE the water
level. Place and set with hydraulic cement. The air
regulator holder (part #17) should finish flush with the
inner pool wall. Drill a 1/2" hole in the tile line even with
the center hole of the air regulator holder. Tile over the
air regulator holder. CAUTION: DO NOT plug the center
hole of the air regulator holder.
C.
Insert the M10 x 80 mm brass screw (part #24) through
the bottom part of the air regulator (part #23), the 42
x 11 x 2 mm and the air regulator gasket (part #26).
Thread the M10 x 80 mm brass screw into the center of
the air regulator holder (part #17). Tighten with a flat
head screw driver.
D.
Install the hose ring (part #25) and snap the top part of the air regulator (part #22) into place. See Figure 11 for air
regulator assembly.
5. Keep all parts not being used now in original box. Store in a safe place until needed.
NOTE: An extension ring and longer square cover screws (part #9/5) are available (upon request) for applications where the
housing is recessed into the pool wall.
6. Once the concrete or gunite is fully cured and pool wall is completed, install the square cover (part #8) using the four (4)
M6 x 25mm square cover screws (part #9/1).
NOTE: In tile installations, the tile thickness can be compensated for by first installing the clamping ring gasket (part #12)
and clamping ring (part #3) before installing the square cover. The clamping ring and clamping ring gasket are installed using
the eight (8) clamping ring screws (part #9/2, 9/3, or 9/4).
Air Regulator
Water Level
Nozzle
Figure 12
Installation in Concrete or Gunite Pools
3" Minimum
12"
19
20
17
21
Figure 11
Air Regulator Assembly
Air Regulator
Tile
3"
Minimum
Water Level
Air Line
Concrete
Wall
12"
Housing
Suction
Plaster
Figure 13
BaduStream in Concrete or Gunite Pool.
18
26
23
24
25
18
22
Deck
Discharge
Fitting 4"
Pipe
Fitting 4"
o
45
Elbow
13