Intended Use - Black and Decker BEHT100 Manual De Instrucciones

English
Minimum gauge for Cord sets
Total length of Cord in Feet
Volts
120 V 25 (7.6)
240 V 50 (15.2) 100 (30.5) 200 (61.0) 300 (91.4)
Ampere Rating
More not
Than More
Than
0 6 18
6 10 18
10 12 16
12 16 14
The label on your tool may include the following symbols. The
symbols and their definitions are as follows:
V ......................... volts
Hz ....................... hertz
min ..................... minutes
or DC ...... direct current
...................... Class I Construction
(grounded)
.../min .............. per minute
BPM .................... beats per minute
IPM ..................... impacts per minute
RPM .................... revolutions per
minute
sfpm ................... surface feet per
minute
SPM .................... strokes per minute
A ......................... amperes
W ........................ watts
or AC ........... alternating current
or AC/DC .... alternating or
direct current
SAVE THESE INSTRUCTIONS FOR
FUTURE USE
COMPONENTS (FIG. A)

WARNING:
tool or any part of it. Damage or personal injury
could result.
Refer to Figure A at the beginning of this manual for a
complete list of components.

Intended Use

This hedge trimmer is designed for residential
trimming applications.
DO nOT use under wet conditions or in presence of
flammable liquids or gases.
This hedge trimmer is a residential power tool. DO nOT
let children come into contact with the tool. Supervision is
required when inexperienced operators use this tool.
4
(meters)
50 (15.2) 100 (30.5) 150 (45.7)
American Wire gauge
16 16
16 14
16 14
12 Not Recommended
...................... Class II
Construction
(double insulated)
n o ....................... no load speed
n ......................... rated speed
...................... earthing terminal
..................... safety alert symbol
..................... visible radiation
..................... wear respiratory
protection
..................... wear eye
protection
..................... wear hearing
protection
..................... read all
documentation
CSPM .................. cut strokes per
minute
Never modify the power
ASSEMBLY

WARNING:
serious personal injury, turn unit off and
disconnect it from power source before making
any adjustments or removing/installing
attachments or accessories. An accidental start-up
can cause injury.
14
Assembly Tools Required (Not Supplied)
12
• Phillips Screwdriver
12
Attaching Guard to trimmer

WARNING:
guard properly assembled to hedge trimmer.
The use of the hedge trimmer without the proper
guard or handle provided may result in serious
personal injury.
The trimmer is shipped with the guard unattached to the
trimmer. To attach the guard:
• Remove guard retaining screw
screwdriver (not supplied).
• Position the guard in place as shown in Fig. B. Ensuring
the guard slots into the grooves on the unit.
Fig. B
• Insert the guard retaining screw
on the side of the guard and tighten securely as shown
in Fig. C.
Fig. C
10
Attaching Extension Cord to Trimmer

WARNING:
is not engaged to reduce the risk of starting the
appliance accidentally.
A cord retainer is incorporated into the rear of the handle on
the power head.
To reduce the risk of
Only use with handle and
10 with the Phillips
10
10
Ensure the trigger switch
into the opening