Malfunction Table - Siemens HB84E562 Instrucciones De Uso

Area Cleaning agents
Stainless steel Hot soapy water:
Clean using a dish cloth and then dry
with a soft cloth. Remove traces of
limescale, grease, starch and albumin
(e.g. egg white) immediately. Corrosion
can form under such residues. Special
stainless steel cleaning agents can be
obtained from the after-sales service or
from specialist retailers.
Cooking compart- Hot soapy water or a vinegar solution:
ment made of stain- Clean using a dish cloth and then dry
less steel with a soft cloth.
If the oven is very dirty: use oven
cleaner, but only when cooking com-
partment is cold. It is best to use a stain-
less-steel sponge. Do not use oven
spray or other aggressive oven cleaners
or abrasive materials. Scouring pads,
rough sponges and pan cleaners are
also unsuitable. These agents scratch
the surface. Allow the interior surfaces
to dry thoroughly.
Door panels Glass cleaner:
Clean with a dish cloth. Do not use a
glass scraper.
Glass cover for the Hot soapy water:
cooking compart- Clean with a dish cloth.
ment light
Door seal Hot soapy water:
Do not remove. Clean with a dish cloth; do not scrub. Do
not use a metal or glass scraper for
cleaning.

Malfunction table

Malfunctions often have simple explanations. Please refer to the
malfunction table before calling the after-sales service.
If a meal does not turn out exactly as you wanted, refer to the
Tested for you in our cooking studio section, where you will
find plenty of cooking tips and tricks.
Malfunction table
Problem
The appliance does not work
Three zeros are flashing in the dis-
play.
The appliance is not in operation. A
cooking time appears in the display.
The microwave does not switch on.
12
Possible cause
Faulty circuit breaker
Plug not plugged in
Power cut
Incorrect operation
Power cut
The start button was not pressed after the set-
ting had been made.
The door was not fully closed.
The button has not been pressed.
†
Area Cleaning agents
Accessories Hot soapy water:
Soak and clean with a dish cloth or a
brush.
Cleaning the glass cover
The glass oven-light cover is located on the left side wall inside
the oven. Undo the screw from the cover. Then you can clean
the glass with soapy water.
Self-cleaning surface in the cooking compartment
The back panel of the oven is coated with self-cleaning enamel.
It cleans itself while the oven is in operation. Sometimes, larger
splashes of food may not disappear until the oven has been
operated several times.
Notes
Never treat the self-cleaning surface with oven cleaner. If
■
oven cleaner accidentally gets onto the rear wall, remove it
immediately with a sponge and plenty of water.
Never use abrasive cleaning agents. You will scratch or
■
destroy the highly porous coating.
Never clean the self-cleaning surface with a scouring pad.
■
Light discolouration of the enamel does not affect self-
■
cleaning.
Cleaning the cooking compartment floor, ceiling and side
walls
Use a dish cloth and hot soapy water or a vinegar solution.
It is best to use oven cleaner if there are very heavy deposits of
dirt. Only use oven cleaner in a cold oven.
:
Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be carried
out by one of our trained after-sales engineers.
Remedy/information
Look in the fuse box to make sure that the
fuse for the appliance is OK.
Plug the plug in
Check whether the kitchen light works.
Disconnect the fuse in the fuse box. Recon-
nect it after approx. 10 seconds.
Reset the clock.
Press the start button or switch off the appli-
ance.
Check whether food remains or foreign
material is trapped in the door. Make sure
that the sealing surfaces are clean. Check
whether the door seal is twisted.
Press the button.
†