How To Assembly The Blades & Light Kit - Fanimation The Mariano FP7930PWW-220 Manual Del Propietário Y Guía

How to Assemble the Blades and Light Kit
1. Remove the blade bushing cover (Figure 1).
2. Position the blade over the blade holder with
threaded posts showing. Make sure the bottom
edge of the blade is fully seated against the blade
arm. With a Phillips screwdriver, tighten 3/16-24 x
8 mm washer head screws and fiber washers to
secure the blade to the blade arm (Figure 2).
CAUTION
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled
may result in damage to the fan blades.
3. Remove and discard rubber motor stops (Figure 3).
4. Secure the blade holders to the motor support
using the 1/4-20 x 14 mm screws through the holes
located on the top of the motor support (Figure 4).
Periodically check blade holder hardware and
NOTE:
resecure if necessary.
!
To reduce the risk of personal injury, do not bend the
blade holders when installing, balancing the blades
or cleaning the fan. Do not insert foreign objects in
between the rotating blades.
WARNING
BLADE BUSHING COVER
3/16-24 x 8 mm WASHER
HEAD SCREW AND FIBER
WASHER (3 each per blade)
BLADE HOLDER
HARDWARE USED:
3/16-24 x 8 mm
WASHER HEAD
SCREWS
FIBER WASHER
HARDWARE USED:
1/4-20 x 14 mm
SCREWS
10
Figure 1
BLADE
Figure 2
x 20
x 20
RUBBER
MOTOR STOPS
MOTOR
ASSEMBLY
Figure 3
1/4-20 x 14 mm SCREWS
(2 per assembly)
BLADE HOLDER
Figure 4
MOTOR SUPPORT
x 10