Installing the Canopy Housing (continued)
2.
Securely attach and tighten the canopy screw cover
over the shoulder screws in the hanger bracket utilizing
the keyslot twist-lock feature. (Figrue 16)
How to Assemble the Blades and Light Plate Assembly
1.
Remove the five rubber motor stops from the motor
assembly. Discard the stops and retain the screws
for the next step. (Figure 17)
2. Assemble the flywheel to the motor assembly using
the previously removed screws. (Figure 18)
3. Position the blade over the blade holder with
threaded posts showing. Make sure the bottom edge
of the blade is fully seated against the blade holder.
With a Phillips screwdriver, tighten #8-32 x 8 mm
Truss head screws and flat washers to secure the
blade to the blade holder. (Figure 19)
CAUTION
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled
may result in damage to the fan blades.
Rubber motor
stops
Fan Motor
Assembly
Blade Holder
HARDWARE USED:
#8-32 x 8 mm
TRUSS WITH
HEAD SCREWS
FLAT WASHER
8
Canopy Screw
Cover
Figure 16
Figure 17
Fly wheel
Figure 18
#8-32 x 8 mm
Truss head screws
and Flat Washer (3 each per blade)
BLADE
Figure 19
x 15
x 15