Tools Needed For Assembly; Unpacking Instructions - Fanimation The Mariano FP7930PWW-220 Manual Del Propietário Y Guía

This manual is designed to make it as easy as possible for you to assemble,

Tools Needed for Assembly

One Phillips head screwdriver
One stepladder
Three wire connectors (supplied)
!
Before assembling your ceiling fan, refer to section
on proper method of wiring your fan (page 8). If you
feel you do not have enough wiring knowledge or
experience, have your fan installed by a licensed
electrician.
For your convenience, check-off boxes are provided next to each step. As each step is completed, place a check
mark in the box. This will insure that all steps have been completed and will be helpful in finding your place should
you be interrupted.
!
Do not install or use fan if any part is damaged or
missing. This product is designed to use only those
parts supplied with this product and/or any
accessories designated specifically for use with this
product by Fanimation. Substitution of parts or
accessories not designated for use with this product
by Fanimation could result in personal injury or
property damage.
1. Check to see that you have received the following parts:
NOTE: If you are uncertain of part description, refer to
exploded view illustration.
install, operate and maintain your ceiling fan
One wire stripper
One 1/4" blade
screwdriver
WARNING

Unpacking Instructions

WARNING
Materials
Wiring outlet box and box connectors must be of type
required by the local code. The minimum wire would be a
3-conductor (2-wire with ground) of the following size:
Installed Wire Length
Up to 50 ft.
50-100 ft.
NOTE: Place the parts from the loose parts bags in a small
container to keep them from being lost. If any parts are
missing contact your local retailer.
screws
4
Wire Size A.W.G.
14
12
– 3/16-24 x 8 mm
(blade to blade holder)
–
(blade to blade holder)
– 1/4"-20 x 14 mm
(blade arm to motor)
– Phillips Screwdriver, 4"
–
–
GLASS
Assembly