How To Assemble The Blades And Light Kit Assembly - Fanimation The Avaston FP6210 Serie Manual Del Propietário

How to Assemble the Blades and Light Kit Assembly

1. Assemble the blades and support plates to the
blade supports of motor assembly using the M16 x 25
mm socket head cap screws with the allen wrench.
(Figure 20)
CAUTION
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled
may result in damage to the fan blades.
2. Remove the three screws in the motor assembly.
Assemble the light plate assembly to the motor
assembly using the previously screws and securely
tighten all three screws. (Figure 21)
3. Connect the 2 single-pin connectors from the motor
assembly to the 2 single-pin connectors from the socket
plate assembly. (Figure 22)
CAUTION
To reduce the risk of electric shock, disconnect the
electrical supply circult to the fan before installing
light kit.
4. Remove one of the three screws in the light
plate assembly. Slightly loosen the remaining two
screws. Assemble the socket plate assembly to the
light plate assembly using the two key slots.
Replace the third screw and securely tighten all three
screws. (Figure 23)
M16x25 mm
Socket Head Cap Screws
Support Plate
Blade support
HARDWARE USED:
M16 X 25 mm
SOCKET HEAD
CAP SCREW
ALLEN WRENCH
11
Figure 20
Blade
x 6
x 1
Motor
Assembly
Light Plate Assembly
Figure 21
Motor
Assembly
Socket Plate Assembly
Figure 22
Light Plate
Assembly
Socket Plate
Assembly
Figure 23