How To Assemble Your Light Kit Assembly Or Cap - Fanimation ODYN FPD8159 Serie Manual De Instrucciones

How to Assemble Your Light Kit Assembly or Cap

1. Remove the six screws in the support bracket at the
bottom of the motor assembly. Assemble the light
plate assembly to the support bracket using the
previously removed screws. (Figure 1)
2. Remove the three screws in the light plate
assembly. Assemble the light kit assembly to the light
plate assembly using the previously removed screws.
(Figure 2)
3. (Option A--for use with light kit)
Remove the three screws in light kit assembly and
retain for Step 4. Connect the 2 pin connectors from
the LED assembly to the 2 pin connectors from motor
assembly. (Figure 3A)
CAUTION
To reduce the risk of electric shock, disconnect the
electrical supply circuit to the fan before installing
your light kit.
3. (Option B--for use with steel cap)
If you want to install the steel cap and not the light kit.
Assemble the steel cap to the light kit assembly by
twisting in a clockwise direction. (Figure 3B)
NOTE: If you have installed your fan with the steel
cap, skip steps 4 and 5.
4. Assemble the LED assembly to the light kit
assembly using the screws removed in Step 3A.
(Figure 4)
CAUTION
The light source is designed for this specific
application and can overheat if serviced by untrained
personnel. If any servicing is required, the product
should be returned to an authorized service facility
for examination or repair.
5. Secure the glass to light kit assembly by twisting
in a clockwise direction. Do not over-tighten. (Figure 5)
Light Kit
Assembly
Light Kit
Assembly
LED Assembly
Figure 3A
Glass
13
Figure 1
Figure 2
Motor
Light Kit
Assembly
Steel Cap
Figure 3B
LED Assembly
Figure 4
Figure 5
Light Plate
Assembly
Light Plate
Assembly