Safety Features - Hobart H66 Manual De Uso Y Mantenimiento

GB
•
Failure to comply with the above, may compromise the safety of the appliance.
•
The appliance must not remain plugged into the mains when not in use.
•
Use the special baskets for dishes and glasses.
•
Do not leave the appliance exposed to the elements.
•
Do not start the appliance if not correctly plugged into the mains and complying with the safety
specifications, i.e. voltage, frequency and fuse cut-off as specified on the plate.
•
The technician must check the efficiency of all earth connections.
•
The technician must provide the customer with a writ declaring that the appliance has been installed and
tested by the book and in compliance with all rules.
1.
Do not start the washing cycle without the filter or the overflow cap.
2.
Before emptying the appliance, remember to cut-off the power supply.
3.
Do not let magnetic objects near the appliance as these may set it off, even with the door open.
4.
Do not use the door as a resting surface.
5.
Do not clean the appliance using direct water jets.
6.
The appliance cannot be used by unauthorised or unsuitably trained personnel, or by anyone who
cannot be given proper instructions.
7.
Do not leave the appliance plugged into the mains when not in use.
8.
In the event of a malfunction, or in the presence of leaks, switch off the appliance immediately
6
5
Faults are easily seen from the messages on the screen (5 and 6) and from any interruption of the
operations in progress only in cases (1 and 3) listed below
WARNING! Turning the machine off and then on again resets the warning, which will appear again if
the problem has not been resolved.
TANK NOT FILLED OR OVERFILLED
1
(if ≥10 min have elapsed, correct level of water has not been reached in the
2
(if the probe is not connected correctly or damaged)
(if the probe is short circuited or damaged)
3
(excessive boiler and tank temperature)
4
5
(if the probe is not connected correctly or damaged)
(if the probe is short circuited or damaged)
USE AND MAINTENANCE MANUAL
The board can recognize various breakdowns.
PROBLEM:
tank)
BOILER PROBE FAILURE
OVERTEMPERATURE
(intervention safety thermostat)
RINSE
(Rinse not effected)
(Insufficient rinse pressure)
(Excessive rinse pressure)
TANK PROBE FAILURE
3.2

SAFETY FEATURES

Display on the Message
Boiler (6)
Tank
Pag. 7
(5)