Connection To The Drain Line; Adjustments And Checks; Rinse-Aid Dispenser - Hobart H66 Manual De Uso Y Mantenimiento

GB
Hardness
Residual
Minerals
B
USE AND MAINTENANCE MANUAL
Specification
French degrees
German degrees
English degrees
Parts per million
Maximum
2.4
The tank empties by gravity, so the drain needs to be
situated below the base of the machine.
The drain pipe needs to be connected to a drain- trap built
into the floor.
The drain dimensions are shown in the installation drawing.
The temperature of the wash tank is regulated by a fixed thermostat at
about 55° C. This temperature ensures proper action by the chemicals
contained in industrial dishwashing detergents.
The boiler temperature set by a fixed thermostat is about 85° C.
To adjust use the ring nut (B) situated at the center of the
dispenser, rotating
counterclockwise increases it.
The dispenser must not operate empty
An excessive amount of rinse agent causes bluish stripes on the
dishes and creates foam in the wash tank.
If the glassware is covered with droplets of water and it dreis rather
slowly this means that the amount of rinse agent is insufficient.
7 cm. of tubing = 1 gram of product
From
5
f
4
°dH
5
°e
70
ppm
mg/l

CONNECTION TO THE DRAIN LINE

2.5

ADJUSTMENTS AND CHECKS

2.6

RINSE-AID DISPENSER

clockwise reduces
Pag. 5
To
10
7'5
9,5
140
300/400
the quantity,