Tabla de contenido
Idiomas disponibles
Idiomas disponibles
BM 2610006360 03-09:BM 2610006360 03-09 3/18/09 1:42 PM Page 9
If necessary, wipe the blade clean. Only then
should the saw teeth protector be removed.
Insert plug into power source and turn tool on
briefly (See Operating Instructions Section).
This will allow the saw blade pin to engage
into the blade, which drives the blade back
and forth. Turn tool off.
To change the blade, place the saw teeth
protector onto the blade and press the "Clic "
button. This causes the tab to spring out of
the locking spring, then remove the blade.
Assembly of Miter Table Attachment FS2000
MOUNTING MITER TABLE ATTACHMENT
USING CLAMPS
Remove the thumbscrew from the storage
area located on the underside of the miter
table fixture (Fig. 2).
Place the stop on the table attachment
against the edge of the workbench or table,
and fasten the miter table attachment with
the aid of the two matching table clamps (not
included). To do this properly, slide the table
clamps in completely in (Fig. 9).
FIG. 9
STOP
T BLE
CL MP
included)
(Not included, available as accessory)
T BLE
CL MP
included)
(not
FIG. 8
SM LL
T B
L RGE T B
MOUNTING MITER TABLE ATTACHMENT
Your miter table attachment is equipped with
two mounting holes that will allow you to
more permanently mount the miter table
attachment to a surface without the use of
the table clamps (Fig. 10). To attach, simply
screw two screws of sufficient length (not
provided) through the two holes provided in
the miter table attachment and into the
mounting surface.
FIG. 10
(not
ATTACHING THE SAW
Place the tool as shown in figure 2 on the
pivoting saw holder of the turntable and
secure with thumbscrew. Make sure that the
guide pins located on the miter table
attachment engage in the holes on the tool.
-9-
DRIVE PIN
LOCKING
SPRING
WITH SCREWS
MOUNTING
SCREW HOLE
MOUNTING
SCREW HOLE
HOOK
Tabla de contenido
