Getting Started; Inserting The Battery; Replacing The Battery - Hama RCW500 Instrucciones De Uso

G Operating instruction
Thank you for choosing a Hama product.
Take your time and read the following instructions and
information completely. Please keep these instructions
in a safe place for future reference. If you sell the device,
please pass these operating instructions on to the new
owner.
1. Explanation of Warning Symbols and Notes
Warning
This symbol is used to indicate safety instructions or to
draw your attention to specific hazards and risks.
Note
This symbol is used to indicate additional information or
important notes.
2. Package Contents
• RCW500 DCF wireless wall clock
• 1 AA battery
• These operating instructions
3. Safety Notes
• Protect the product from dirt, moisture and overheating,
and only use it in a dry environment.
• Do not use the product in areas where the use of
electronic devices is not permitted.
• Do not drop the product and do not expose it to any
major shocks.
• Do not put the product near interference fields, metal
frames, computers, TVs, etc. Electronic devices and
window frames can negatively affect the product's
functionality.
• Do not modify the product in any way. Doing so voids
the warranty.
• Keep the packaging material out of the reach of children
due to the risk of suffocation.
• Dispose of packaging material immediately according to
locally applicable regulations.
2
Warning – Batteries
• Immediately remove and dispose of dead batteries
from the product.
• Only use batteries (or rechargeable batteries) that
match the specified type.
• When inserting batteries, note the correct polarity (+
and - markings) and insert the batteries accordingly.
Failure to do so could result in the batteries leaking or
exploding.
• Do not overcharge batteries.
• Keep batteries out of the reach of children.
• Do not short circuit the batteries/rechargeable
batteries and keep them away from uncoated metal
objects.

4. Getting Started

4.1 Inserting the battery

Open the battery compartment, remove the contact
breaker and then close the battery compartment. The clock
is ready for operation.

4.2 Replacing the battery

• Open the battery compartment on the back of the
product.
• Remove and dispose of any used batteries. Insert the
new battery (AA). Ensure that the polarity of the battery
corresponds to the symbols in the battery compartment.
• Close the battery compartment.
5. Installation
Alternatively, you can install the wireless wall clock on a
wall using the opening on the back.
Warning – Mounting Note:
• Before mounting the clock, ensure that the chosen
wall is suitable for the weight to be mounted, and
make sure that there are no electrical wires, water,
gas or other lines at the installation site on the wall.
• Purchase special fastening materials from specialised
dealers.