Installing And Removing The Battery Pack - DeWalt DCPS620 Manual De Instrucciones

Fig. H
Fig. I
Fig. J
Fig. K
Joining Center Extension to Saw Head
Module and Handle Module (Fig. A, L)
Adding the center extension
and saw head assembly 3
approximately 10' (3 m) in length as shown in Figure L.
Refer to to Joining Saw Head Module to Handle Module
for directions on how to attach the middle assembly to the
handle assembly and saw head assembly.
Fig. L

WARNING: Always check to make sure that the
sleeve is completely threaded on and that the red
threads are no longer visible. Not threading the sleeve
completely on could result in the assemblys becoming
disconnected creating a hazardous condition.
Periodically check the connections to insure that no
red threads are visible.
1 21
3
22
2 to the handle assembly
creates a pole saw that is
DISASSEMBLY

WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
Detaching Saw Head Module (Fig. M)

WARNING: Sharp moving blade. To prevent
accidental operation, insure that battery is
disconnected from the handle and that the protective
scabbard is in place on the chain before performing
the following operations. Failure to do this could result
in serious personal injury.
When detaching the assemblies, whether it is in the two
assembly or three assembly mode, always detach the saw head
assembly 1 first. To do this, rest the handle assembly
the ground and grasp the center of the saw head assembly
with one hand as shown in Figure M. Use your other hand to
loosen the threaded sleeve and then pull the two halves apart.
9
Repeat this process if the center extension was attached.
Fig. M
OPERATION
1

WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.

Installing and Removing the Battery Pack

(Fig. N)
nOTE: For best results, make sure your battery pack is
fully charged.
To install the battery pack
battery pack with the rails inside the tool's handle and slide
it into the handle until the battery pack is firmly seated in
the tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the release
button 23 and firmly pull the battery pack out of the tool
handle. Insert it into the charger as described in the charger
section of this manual.
English
1
2
6 into the tool handle, align the
2 on
11