Methods Of Operation - Hitachi N 5024A2 Instrucciones Y Manual De Seguridad

WARNING
Choice of triggering method is
important.
Please read and
"METHODS OF OPERATION" found
below.
Never place your face, hands or feet
near firing head when using.
Do not drive staples on top of other
staples or with Stapler at too steep of
an angle; staples can ricochet and hurt
someone.
In order to avoid double fire or
unwanted ejection of a staple due to
bouncing of the Stapler.
1) do not push Stapler on workpiece
with strong force;
2) take Stapler away from workpiece
using recoil;
3) release trigger quickly when
performing trigger fire.
Do not drive staples into thin boards
or near corners and edges of
workpiece. Staples can be driven
through or away from workpiece and
hit someone.
Never drive staples from both sides of
a wall at the same time. Staples can
be driven into and through the wall
and hit a person on the opposite side.
Never use Stapler which is defective
or operating abnormally.
Do not use Stapler as hammer.
Disconnect air hose from Stapler
when:
1) turning the adjuster;
2) it is not in use;
3) leaving work area;
4) moving it to another location; and
5) handing it to another person.
NEVER point tool
at yourself or
others in work
area.
Keep fingers
AWAY from
trigger when not
driving staples to
avoid accidental
firing.
understand
— 15 —
This Hitachi Stapler has a STANDARD
CONTACT TRIP MECHANISM (Bounce Fire).
An OPTIONAL
MECHANISM kit (SINGLE SHOT) is available
as order part number 876762.
THE STANDARD
MECHANISM (Bounce Fire) is for use where
rapid fastener placement is desired and must
be operated in accordance with the following

"Methods of Operation".

METHODS OF OPERATION
This Stapler is equipped with the push lever
and does not operate unless the push lever
is depressed (upward position).
There are two methods of operation to drive
staples with this Stapler.
They are:
1. Intermittent operation (Trigger fire):
2. Continuous operation (Push lever
fire):
(1) Intermittent operation (Trigger fire)
1 Position the staple outlet on the
workpiece with finger off the trigger.
2 Depress the push lever firmly until it
is completely depressed.
3 Pull the trigger to drive a staple.
4 Remove finger from the trigger.
To drive another staple, move the Stapler
along the workpiece and repeat this
procedure.
2
Push lever
(2) Continuous operation (Push lever fire)
To avoid double firing or accidental
firing due to recoil.
English
SEQUENTIAL
CONTACT
Trigger
3
WARNING
TRIP
TRIP