Methods Of Operation - Hitachi N 3808AP Instrucciones Y Manual De Seguridad

English
● When working close to an edge of a
workpiece or at steep angles, or driving
fasteners into thin workpiece use care to
minimize chipping, splitting or splintering, or
free fl ight, ricochet or piercing of fasteners,
which may cause injury.
● Never drive staples from both sides of a wall
at the same time. Staples can be driven into
and through the wall and hit a person on the
opposite side.
● Never use Stapler which is defective or
operating abnormally.
● Do not use Stapler as hammer.
● Disconnect air hose from Stapler when:
1) it is not in use;
2) leaving work area;
3) elevating, lowering or otherwise moving it
to another location;
4) handing it to another person;
5) changing switching device;
6) performing any maintenance or repairs;
7) clearing a jam;
8) Stapler is outside of the operator's
supervision or control;
9) removing staples and caps from the
magazine;
10) adjusting stapling depth;
11) turning the top cover; and
12) When affi xing the hook
There are two types of operation to drive staples with this
Stapler.
Use CONTACT ACTUATION MECHANISM or SINGLE
SEQUENTIAL ACTUATION MECHANISM in accordance
with the work to be performed.
Explanation of the various stapling operations
○ CONTACT ACTUATION MECHANISM: First, press
the push lever against the workpiece; next, pull the
trigger to drive the staple. Or,
pull the trigger; next, press the push lever against the
workpiece to drive the staple.
If the trigger is held back, a staple will be driven each
time the push lever is pressed against the workpiece.
N3808AP is shipped with SEQUENTIAL ACTUATION
KIT.
When switching from SEQUENTIAL ACTUATION
KIT TO CONTACT ACTUATION KIT, replace to
CONTACT ACTUATION KIT.
18
Rubber Ring
○ SINGLE SEQUENTIAL ACTUATION MECHANISM:
First, press the push lever against the workpiece;
next, pull the trigger to drive the staple.
After stapling once, stapling will not be possible again
until the trigger is released and pressed again.

METHODS OF OPERATION

This Stapler is equipped with the push lever and does not
operate unless the push lever is depressed (upward position).
There are three methods of operation to drive staples with
this Stapler.
They are:
1. Intermittent operation (Trigger fi re):
CONTACT ACTUATION MECHANISM, SINGLE
SEQUENTIAL ACTUATION MECHNISM
2. Continuous operation (Push lever fi re):
CONTACT ACTUATION MECHANISM
3. Single sequential operation (Trigger fi re):
SINGLE SEQUENTIAL ACTUATION MECHANISM
(1) Intermittent operation (Trigger fi re)
Recommend to
ACTUATION MECHANISM
● To avoid double fi ring or accidental fi ring due
to recoil.
1) Pull the trigger rapidly and fi rmly.
1 Position the staple outlet on the workpiece with
fi nger off the trigger.
2 Depress the push lever fi rmly until it is completely
depressed.
3 Pull the trigger to drive a staple.
4 Remove fi nger from the trigger.
To continue stapling in a separate location, move the
stapler along the workpiece, repeating steps 1 – 4 as
required.
Pin
Sequential
actuation trigger kit
Contact actuation trigger kit
use SINGLE SEQUENTIAL
WARNING