Back Height Adjustment; Back Angle Adjustment - Invacare Matrx FSMH Manual De Usuario

TRD0238- Fixed Space Saver Kit Installation (CE (europe)-rev 4.0_ International_Layout 1 21/12/2011 10:00 AM Page 5
3.0 Pre-Installation Set-Up and Adjustment
3.1 Mounting Clamp and Plate Adjustments ...cont'd:
ii) BACK HEIGHT ADJUSTMENT:
Figure 4
The height of the mounting clamp (Back
Cushion) may be adjusted along the
back canes by loosening the clamp hard-
ware and lsiding the complete assembly
up or down to the desired height- refer
to Figure 3 at right.
(Note: to ensure proper set-up, the
mounting plates/clamps must be in-
stalled at the same height on each back
cane).
iii) BACK ANGLE ADJUSTMENT:
Figure 5
The slotted mounting plates are also de-
signed to allow simple back angle ad-
justment for the MaTRx back. By
loosening the mounting hardware, the
plates can be rotated to alter the back
angle and better conform to the needs
of the client (see Figure 4 at right).
Front of
wheelchair
Back angle adjustment on
a Cane Clamp assembly.
5