Connecting The Voltage Supply - Eaton xChargeIn Manual De Instalación

Connections and wiring
7.3.2

Connecting the voltage supply

The charging station can be connected in the following ways:
●
●
The supply terminals are designed as spring-type terminals. The handling in-
structions enclosed in the terminal area must be observed.
Caution
Risk of breaking the terminal!
Do not press the screwdriver up, down or to the side!
To connect the supply voltage, proceed as follows:
1) Shorten the connection wires to the appropriate length (as short as pos-
2) Strip the connection wires to approx. 12 mm. For stranded wires with
3) Insert the flat-head screwdriver (5.5 mm) into the supply terminal as
32
1-phase: via terminals L1, N and
3-phase: via terminals L1, L2, L3, N and
sible). The protective conductor
conductors!
fine wires, use wire end sleeves.
shown. The screwdriver must rest on the housing.
PE
PE
PE must be longer than the other
Installation manual V1.01
xChargeIn
© EATON