Tabla de contenido
Idiomas disponibles
Idiomas disponibles
HOW TO USE YOUR PRESSURE
WASHER
if you have any problems operating your pressure
washer, please call the pressure washer helpline at
1-800-222-3136.
Pressure
Washer
Location
Pressure Washer Clearance
WARNING
Operate
pressure
washer
ONLY
outdoors,
Keep
exhaust
gas from entering
a confined
area through
windows,
doors,
ventilation
intakes
or other openings,
DO NOT operate
pressure
washer
inside
any building
or
enclosure,
The pressure washer must be at least 5 ft. (152 cm)
from structures having combustible walls and/or other
combustible materials. Leave at least 3 ft. (92 cm) all
around pressure washer including overhead, for
adequate cooling, maintenance and servicing.
Place pressure washer in a well ventilated area, which
will allow for removal of deadly exhaust gas. DO NOT
place pressure washer where exhaust gas could
accumulate and enter inside or be drawn into a
potentially occupied building. Ensure exhaust gas is
kept away from any windows, doors, ventilation
intakes or other openings that can allow exhaust gas
to collect in a confined area. Prevailing winds and air
currents should be taken into consideration when
positioning pressure washer.
To Start Your
Pressure
Washer
To start your engine-powered
pressure washer for the
first time, follow these instructions step-by-step. This
starting information also applies whenever you start
the engine after you have let the pressure washer sit
idle for at least a day.
1.
Place pressure washer near an outside water
source capable of supplying water at a flow rate
greater than 2.9 gallons per minute and no less than
20 PSI at pressure washer end of garden hose.
2.
Check that high pressure hose is tightly connected
to spray gun and pump. See "Assembling Your
Pressure Washer" for illustrations.
3.
Make sure unit is in a level position.
4.
Connect garden hose to water inlet on pressure
washer pump. Turn ON water.
CAUTION
• Damage
to equipment
will result from failure
to follow
this instruction.
5.
Squeeze trigger on gun to purge pump system of
air and impurities.
6.
Place colored quick connect spray tips in slots on
holder that's attached to nozzle extension.
7.
Attach nozzle extension to spray gun. Tighten by
hand.
Typical
Pressure
Washer
Shown
Exhaust Port
8.
Choose spray tip you want to use, pull back on
collar of nozzle extension, insert spray tip and
release collar. Tug on spray tip to make sure it is
securely in place. See "How to Use Spray Tips".
9.
Engage trigger lock to spray gun trigger.
Trigger Lock
_J
Tabla de contenido
