Tabla de contenido
Idiomas disponibles
Idiomas disponibles
.
.
Pull back collar on quick-connect
and pull current
spray tip off. Store spray tips in holder provided on
the nozzle extension.
Select desired spray tip:
•
For gentle rinse, select white 40 ° spray tip.
•
To scour surface, select yellow 15° or red 0°
spray tip.
•
To apply chemical, select black spray tip.
Low Pressure
Black
Use to apply
chemical
High Pressure
////
40 ° White
15° Yellow
0 ° Red
Usage Tips
•
Pull back on collar, insert new spray tip and
release collar. Tug on spray tip to make sure it is
securely in place.
•
For most effective cleaning, keep spray tip from
8 to 24 inches away from cleaning surface. If you
get spray tip too close, you may damage cleaning
surface.
•
DO NOT get closer than 6 inches when cleaning
tires.
Cleaning
and Applying
Chemical
IMPORTANT:
Use chemicals
designed
specifically
for pressure
washers.
Household detergents could
damage the pump.
CAUTION
.
2.
.
Starting
the engine
without
all the hoses
connected
and
without
the water
turned
ON will damage
the pump.
Damage
to equipment
resulting
from failure
to follow
this
instruction
will void warranty,
Review spray tip use.
Prepare detergent solution as required by
manufacturer.
Place filter end of detergent siphoning tube into
detergent container.
CAUTION
When
inserting
the filter into
a detergent
solution
bottle,
route the tube so as to
keep
it from
inadvertently
contacting
the hot muffler.
4.
Make sure black spray tip is installed.
NOTE: Detergent cannot be applied with the high
pressure spray tips (White, Yellow, or Red).
5.
Make sure garden hose is connected to water
inlet. Check that high pressure hose is connected
to spray gun and pump and start engine.
6.
Apply detergent to a dry surface, starting at lower
portion of area to be washed and work upward,
using long, even, overlapping strokes.
7.
Allow detergent to soak in between 3-5 minutes
before washing and rinsing. Reapply as needed to
prevent surface from drying. DO NOT allow
detergent to dry on (prevents streaking).
IMPORTANT:
You must flush the chemical injection
system after each use by placing the filter into a
bucket of clean water, then run the pressure washer in
low pressure for 1-2 minutes.
10
Tabla de contenido
