Tabla de contenido
Idiomas disponibles
Idiomas disponibles
10. Move throttle lever to "Fast" position, shown here
as a rabbit.
Fast
Stop
/
Throttle
Lever in
STOP
position
NOTE: For a warm engine, be sure the throttle lever is
in the "Fast" position.
To start the engine for the very first time:
11. Make sure throttle lever is in "Fast" position
(indicated on the engine as a rabbit).
12. Push primer bulb firmly 5 times, waiting 2 seconds
between each push.
To start engine thereafter:
11. Make sure throttle lever is in "Fast" position
(indicated on the engine as a rabbit).
12. Press primer bulb firmly 3 times, waiting
2 seconds between each push. For a warm
engine, DO NOT press primer bulb.
13. Grasp starter grip handle and pull slowly until you
feel some resistance. Then pull rapidly to start
engine.
WARNING
]
When
starting
engine,
pull cord
slowly
until resistance
is
felt and then
pull rapidly
to avoid kickback.
If engine
starts
and fails to continue
to run or if increased
resistance
is felt during
starting
pull attempts,
squeeze
trigger
on spray
gun.
14. Return starter grip handle slowly. DO NOT let rope
"snap back" against starter.
NOTE: Always keep the throttle lever in the "Fast"
)osition when operating the pressure washer.
a, cAuTmO.
]
• DO NOT move
pressure
washer
while
running.
• Always
use handle
to lift equipment.
• NEVER
pull on hoses
to move equipment.
WARNING
DO NOT touch
hot surfaces.
Allow
equipment
to coo! before
touching.
The pressure
washer
must be at least 5 feet from
structures
having
combustible
walls
and/or
other
combustible
materials.
Keep at least 3 feet of clearance
on al! sides
of pressure
washer
for adequate
cooling,
maintenance
and servicing.
In the State of California
a spark arrester
is required
by law
(Section
4442 of the California
Public Resources
Code).
Other states may have similar
laws. Federal laws apply on
federal
lands. If you equip the muffler
with a spark arrester,
it must be maintained
in effective
working
order.
How to Stop Your Pressure
Washer
1.
Let engine idle for two minutes.
2.
Move throttle lever on engine to "Stop" position.
3.
Squeeze trigger
on spray gun to relieve
trapped
pressure
in hose to avoid injury.
WANNING
Keep high pressure hose connected to pump and spray
gun while system is pressurized.
Squeeze trigger on spray gun to relieve trapped
pressure, every time you stop engine, Engage trigger
lock on spray gun.
NOTE:
A small amount
of water
will squirt out when
pressure
is released.
4.
Engage
trigger
lock on spray
gun when
not in use.
How to Use Spray
Tips
The quick-connect
on the nozzle extension allows you
to switch between four different spray tips. The spray
tips vary the spray pattern as shown above.
Follow these instructions to change spray tips:
1.
Engage trigger lock on spray gun.
CAUTION
NEVER
exchange
spray
tips without
locking
the trigger
lock on the trigger.
Tabla de contenido
