Machine Connection - TECshow BEAMER STREAM Manual De Usuario

Machine Connection

Cable Connectors
Cables must have a male XLR connector on one end and a
female XLR connector on the other end.
A word on termination: DMX is a resilient communication
protocol, however errors still occasionally occur. Termina-
tion reduces signal errors, and therefore best practices in-
clude use of a terminator in all circumstances. If you are ex-
periencing problems with erratic fixture behavior, especially
over long signal cable runs, a terminator may help improve
performance.
To build your own DMX Terminator: Obtain a 120-ohm, 1/4-
watt resistor, and wire it between pins 2&3 of the last fixture.
They are also readily available from specialty retailers.
Complimentary signal cable can transmits signals to 20
unit fixtures at most. Signal amplifier is a must to connect
more fixtures
BEAMER STREAM - 5R BEAM AND LASER SIMULATOR p. 6
ENGLISH VERSION